Built well, but needs design update for cut in headlights.
Built well and looks good, but interferes with cut in headlights. This is mentioned in the mounting instructions, but the solution was to oversize the mounting holes. The guard interferes at least one inch with the headlights so over sizing holes is not going to make it work. This will also make it interfere with fender flares since it is nearly touching the fender flares now. A small amount of redesign would resolve this issue. Disappointing.
Looks good on the cart but I did have to make brackets and move the bottom hole about an inch rearward. This is on an 03 ezgo For the money, I shouldn’t have to make brackets out of 8th inch thick aluminum to secure the front bumper so that it doesn’t bisect the headlights that are mounted in the fender.
Very easy to install. Be careful not to scratch the body when removing the roof brackets. Pole ends are very sharped edge. The brush guard looks awesome. It sits a little high for the front headlights, but haven't check to see if it blocks the lights. I would say BU needs to do a better job packing. I realize this is a large item. It was wrapped in bubble wrap. But box and packing material was limited so it moved alot during shipping. It wore a whole in the box which scratched the bumper. I should complain and return, but it will just get scratched up eventually. Just when you buy something new. It helps if it arrives in pristine condition.